Tips on how to Bypass the Parking Brake pedal Hookup over a Pioneer Auto dvd player

If you have an automobile with a Leader DVD player, it could be that the brain unit is wired to the parking brake system. The purpose of that is to prevent the driver from watching video while driving a vehicle, as this can be distracting.

How to Circumvent the Auto parking Brake Hookup

There are several solutions to bypass the hookup between your Auto dvd unit and the braking system in your vehicle. One of the popular methods is always to disconnect the wire from DVD player and connect this to the black crushed wire in your vehicle.

Another technique is to install a MicroBypass switch that will allow you to watch video clips while you drive. This is a wonderful way to get the most out of your entertainment while you’re on the streets.

How to Eliminate the Plastic Reduce

To bypass the parking brake hookup on a Pioneer head device, you need to earliest remove the plastic-type trim. This would be done delicately so that you do not damage the stereo.

The next phase is to locate the parking brake wire and the ground wire. These can be found at the back of the top unit.

You should have a wire stripper and a pair of needle-nose pliers to eliminate the wire connections. Follow the guidelines in your head unit’s instruction manual intended for guidance.

After that, cut the parking brake pedal wire by 50 % and divided it to show both of them ends. Afterward, remove the efficiency from both sides of each end. Leave about a quarter-inch of exposed cable on each aspect. Then, hook up the ends together and secure them with electrical adhesive tape or an end hat.